Saving Settings; Menu Description - CARLO GAVAZZI WM50 Manual De Instrucciones

Decimal point position (dP)
In the dP position, buttons
ys
1000000) in the following order:
Sign position (Sign)
The value sign can be set in the position Sign. The value is positive by default.

Saving settings

To save settings, scroll the settings menu pages until the End page is displayed and press
CAUTION! Changes are not saved if you exit the settings menu in another way.

Menu description

Measurement menu - meters
A list of the meters displayed is provided below:
Note: displayed meters depend on whether M F I6 06 and M F I6 R4 module inputs are installed and their settings and whether
tariff management is enabled.
Symbol
tot (kWh) Total imported active energy
tot (kvarh) Total imported reactive energy
tot (- kWh) Total exported active energy
tot (- kvarh) Total exported reactive energy
PAr (kWh) Partial imported active energy
PAr (kvarh) Partial imported reactive energy
PAr (- kWh) Partial exported active energy
PAr (- Partial exported reactive energy
kvarh)
t0x (kWh) Active energy per tariff x
t0x (kvarh) Reactive energy per tariff x
Measurement menu - measurement pages
The minimum, maximum, average (dmd) and maximum among average values (max dmd) for each displayed variable can be
viewed for each measurement, touching keys
Note: the available measurements depend on the type of system set.
and can be used to enable decimal point movement and set a multiplier (k x 1000, M x
/
Description
/
ys / .
Symbol
t0x (- kWh) Active energy per tariff x
t0x (- kvarh) Reactive energy per tariff x
C1 Pulse totalizer 1, associated with digital input
4
C2 Pulse totalizer 2, associated with digital input
5
C3 Pulse totalizer 3, associated with digital input
6
HrS Total load operating hours
d t Date and time
WM50 - Instruction manual | 26/04/2022 | CARLO GAVAZZI Controls SpA
WM50 use
.
Description
13