Test Mode; Replace Battery - Trust ZCO-900 Manual Del Usuario

Ocultar thumbs Ver también para ZCO-900:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
EN ZCO-900 ZIGBEE CARBON MONOXIDE DETECTOR

6. TEST MODE

Activate the test mode of the
detector to check the operation
by pressing the Test button.
The LED will flash fast and the
detector will sound.
RESET DETECTOR AND
ACTIVATE CONNECT MODE
Warning: This step will
disconnect the detector from
the Smart Bridge or the ICS-
2000. To reset the detector
press the button in the hole
at the side for approximately
5 sec with the included pin.
The LED will flash 6x to confirm
the reset.
Activate connect mode: After
resetting the detector you can
activate the connect mode by
pressing the button in the
hole on the side for approx.
10
2 sec. The LED will flash fast
for 1 minute to indicate the
connection mode.

REPLACE BATTERY

A
Open the battery
compartment by removing
the detector from the
bracket.
B
Remove the empty battery
and insert a new 3V
CR123A lithium battery in
the compartment. Note
the positive and negative
polarity.
C
Lock the detector back
on the bracket. Test if the
battery is placed correctly
by activating the test mode.
(See step 6).

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

71260

Tabla de contenido