Mounting Accessories - Ferm CDM1104 Traducción Del Manual Original

Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
is not being used and prior to maintenance.
excluded.

3. MOUNTING ACCESSORIES

Prior to mounting an accessory always
remove the battery.
Fitting and removing drill cutters
Fig. B
In addition to screwdriver bits with a hexagonal
shaft, this tool can also accommodate drill bits
with a hexagonal shaft.
grip (9).
when you wish to change the cutter.
Fig. C
block or tool is clean and dry before
connecting the charger.
Fig. A) is in the central position in order to
prevent the appliance from being switched on
unexpectedly.
appliance, as shown on the illustration. Push
the battery until it latches in.
before removing the battery, and disengage
the battery from the base of the appliance.
6
4. OPERATION
Always follow the safety notes and the
relevant safety code.
steadily onto the work piece. Do not overload the
appliance. Only use drill bits with no visible wear.
Worn bits will have a bad effect on the functioning
of the appliance.
Adjusting the torque
Fig. D
The appliance has 16 different torque settings
with which to set the power for driving and
removing screws.
desired position. The available torque settings
are indicated on the adjustment ring by the
numbers 1 to 8 and by dots between the
total).
as possible when using the screwdriver. Select
a higher setting if the motor slips.
Driving and removing screws
position 'R' in order to drive screws.
in order to remove screws.
Drilling
drilling position.
Ensure that the direction reversing
switch (6) is always set to 'R' during
drilling.
Switching the device on and off
Fig. A
speed of the appliance by transmitting power
to the switch.
chuck immediately which will no longer run on.
centre in order to lock the appliance in its
disabled state.