Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION OF SPARE PARTS
(1) Fuel gauge
(5) Air cleaner
(2) Chock valve
(6) Engine switch
(3) Fuel valve lever
(7) DC output
(4) Starter Grip
(8) Ground terminal
Fuel tank
It is used to hold fuel, gasoline is allowed
only.
Fuel tank cap
Screw the fuel injection port in use and do
not open it in equipment operation.
Fuel gauge
It is to indicate fuel level in the fuel tank.
AC output
AC output socket provides the power
supply.,Please refer to model's parameter
table for its rated power. load of each
socket cannot exceed its rated current,
and total power of electric device cannot
surpass rated power of the generator Do
not start up several electric devices
simultaneously, but switch on another
one after stable operation of one electric
device.
AC circuit
It will break to protect the electric device
breaker
when current is too heavy.
Output
It is to indicate power supply status.
indicator
The indicate will brighten up when
the equipment operation.
DC output
The output DC is 12V with maximum of
8.3A. It is only used for automotive battery
charging with rated 12V. Pay attention to
connecting the positive and negative
electrode correctly.
Engine switch
It is to start up (applicable to electrical
starting only) and switch off engine.
Turn to the off state in nonuse.
Wheel
It is for moving the generator in a short
(optional)
time.
Battery
It is for starting up the generator. In case
(optional)
of nonuse for three months, charge it.
Oil filler cap
It is for measurement of engine's oil level.
Make sure engine's oil level is between
MIN and MAX in the dipstick of oil filler
cap before use. Oil can be added after
removing the oil filler cap.
Oil drain bolt
Unscrew this bolt when replacing the
engine oil. Drain out the old engine oil and
dispose of it properly according to local
laws, avoiding damage to the environment.
Foot
It is to support the generator.
Grounding
It is to make the generator realize safe
terminal
grounding. As to the grounding method,
refer to the page 6. Make sure
unobstructed grounding before use.
Handrail pipe After lifted up, the pipe, with self-locking
structure, can be used to move
the generator.
Starter grip
It is to start up the engine.
For the method, refer to the page 7.
(9) Oil drain bolt
(10) Oil filter cap
(11) Battery (optional)
(12) AC output
Air cleaner
Fuel switch
Choke valve
Muffler
Sockets can be following patterns according to relevant
regulations in various areas:
WARNING
5
(13) Output indicator
(14) Panel seat
(15) Fuel tank cap
(16) Fuel tank
It is to filter air and remove impurities
in the air entering cylinder. As to the
maintenance method, refer to page 10.
It is to control fuel's entering into the
engine via fuel tank During nonuse of
generator, leave the switch off.
It is to control air flow into the cylinder
when starting up the engine. As to the
operating method, refer to the page 7.
It is to eliminate noise during equipment
operation, and discharge high temperature
exhaust of engine's combustion. Do not
touch it to avoid scalding.
When the rated current from one socket output more
than the socket's nominal rated current, you should
to use simultaneously two or more sockets for power
output.
(17) Cover, generator end
(18) Muffler
(19) Cylinder head
(20) Carburetor
(21) Spark plug
Publicidad
Tabla de contenido
