Operation Method - KNOVA KN GEN-30 Manual Del Usuario

OPERATION METHOD

READ MANUAL
BEFORE
OPERATING
GENERATOR!
• Unit grounding
Shift the machina outdoors, use wire of no less than 2.5 mm
to make the machina and grounding terminal connected to
the ground. One end of the wire is pressed below the
butterfly nut of the unit, screwed up tightly, and the other
end is connected with the metal rod shape article (such as
the iron nail and the opener), and inserted into soil.
• Starting the generator set
Filling oil
Remove the oil filler cap, fill oil of proper model. As to
dosage, refer to Page 4. Use the funnel far filling, in case of
careless spilling, clean the ground to avoid slipping.
ON
Upper level
START
WAIT
5 SEC.
Oil specification table
SAE
TEMP
AMBIENT TEMPERATURE
Filling fuel
Open the fuel tank cap and fill gasoline, the fuel leveler's
position will display gasoline mass in the fuel tank and take
care the maximum fuel position shall not exceed the inner
strainer of the tank when filling.
WARNING
Keep away from the fire source and heat
source when filling; do not fill gasoline when be operating.
Connect electric battery (electric start only)
2
Turn on the fuel valve lever
ON
6
WAIT
OFF
30 SEC.
No exceeding
this level
Connect the storage battery wire
to the storage battery, red for
positive electrode and green for the
negative electrode, and make sure
screwing the nut tightly. Not contact
between positive electrode to nega-
tive electrode to avoid short circuit.
After connection, metal parts of
two pieces of wire shall keep at
least 15 mm safety distance, and be
protected by rubber cover.
Turn the fuel valve lever to ON
and let the fuel flow into the
carburetor.
OFF