Adjusting Loudness; Using Subwoofer Output; Adjusting Subwoofer Settings; Using Non Fading Output - Pioneer DEH-P7500MP Manual De Instrucciones

Reproductor de cd/mp3/wma de alta potencia consintonizador rds y control de cd múltiple/dab
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Audio Adjustments

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Press AUDIO to select Loud.
Press AUDIO until Loud appears in the dis-
play.
2
Press a to turn loudness on.
Loudness level (e.g., Loud MID) appears in
the display.
3
Press c or d to select a desired level.
Each press of c or d selects level in the fol-
lowing order:
LOW (low)MID (mid)HIGH (high)
4
Press b to turn loudness off.
Loud OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
1
Press AUDIO to select Sub-W1.
Press AUDIO until Sub-W1 appears in the dis-
play.
# When the subwoofer controller setting is
PREOUT:FULL, you cannot select Sub-W1.
2
Press a to turn subwoofer output on.
Sub-W1 Normal appears in the display. Sub-
woofer output is now on.
# To turn subwoofer output off, press b.
3
Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and Rev. ap-
pears in the display. Press d to select normal
phase and Normal appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1
Press AUDIO to select Sub-W2.
Press AUDIO until Sub-W2 appears in the dis-
play.
# When the subwoofer output is on, you can se-
lect Sub-W2.
2
Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
5080125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
3
Press a or b to adjust the output level
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6  6 is displayed
as the level is increased or decreased.

Using non fading output

When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
put through the RCA output.
1
Press AUDIO to select non fading out-
put on/off setting.
Press AUDIO until NonFad ON appears in the
display.
# When the subwoofer controller setting is only
PREOUT:FULL, you can switch to the non fading
output on/off setting. (Refer to page 46.)
2
Press a to turn non fading output on.
NonFad ON appears in the display. Non fad-
ing output is now on.
# To turn non fading output off, press b.
Section
09
41
En

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido