Indicator Light; Control Panel - Flama 1327FL Manual De Instrucciones

ATTENTION:
The dehumidifi er must be placed in a
verti cal positi on for at least 12 hours
before use.
Do not att empt to replace the power cord
or plug, as this is a dangerous operati on.
Have them replaced immediately by a
Flama-authorized technical assistance
service or by similarly qualifi ed technicians
to prevent danger.
DESCRIPTION

1. Control panel

2. Indicator light

3. Water tank
4. Filter
5. Plug for conti nuous drainage
6. Handle
7. Wheels
8. STANDBY butt on (ON/OFF)
9. MODE butt on
10. TIMER butt on
11. Humidity and ti mer control butt ons
12. Display
13. LOCK butt on
14. Filter REST/RESET butt on
15. Fan control butt on
OPERATING INSTRUCTIONS
TURNING THE APPLIANCE ON AND
OFF
Ensure that the water tank is in the correct
positi on (aft er turning on the appliance for
the fi rst ti me, if the full tank indicator turns
on, remove the tank and put it back in the
correct positi on).
Make sure that the appliance is plugged
into the wall outlet.
Turn off the appliance, unplugging it from
the wall outlet.
INDICATOR LIGHT (2)
Ambient humidity <45% - blue light.
45≤ ambient humidity ≤65% - green light.
Ambient humidity >65% - red light.
If the display shows E0, E2, CL, CH, LO or HI,
the light will turn red.
CONTROL PANEL
STANDBY butt on
Press the STANDBY butt on and the
dehumidifi er will begin to operate with an
initi al humidity setti ng of 60%, standard
automati c mode and high fan mode.
Press the POWER butt on again and the
dehumidifi er will cease
operati on.
English
27