Nolan N60-6 Instrucciones página 13

- When riding any motorcycle, always wear the helmet properly fastened in order to
fully exploit its protection.
- Never wear scarves under the fastening system nor caps of any sort under the hel-
met.
- The helmet can muffle traffic noises. However make sure that you can hear essential
sounds such as horns and emergency vehicle sirens.
- Always keep the helmet away from heat sources like the exhaust muffler, the top box
housing or the interior of a vehicle.
- Do not modify and/or tamper with the helmet (even partially) for any reason: any modifications
and/or alterations compromise the safety requirements of the helmet and impair its protection
degree. These also make the helmet no longer conform to the homologation standards, mak-
ing it unusable and invalidate the warranty.
- Avoid contact between the helmet and gasoline and other solvents; do not apply adhesives or
paints to the helmet.
- Helmet damages resulting from accidental falls may not be visible, and any helmet that has
been impacted has to be replaced. Always handle your helmet carefully in order not to com-
promise or reduce its protection degree.
- If the visor and/or sunscreen that may be present in the helmet are damaged and/or have
marked scratches that reduce visibility, their protective treatment has likely been compro-
mised, and therefore they must be replaced.
- The visor and/or sunscreen that may be present in the helmet can only be used with the helmet
model for which they were designed.
- Use only original accessories and/or spare parts suitable for your specific helmet model.
- In case of doubt about the helmet's integrity and/or safety, avoid using it and contact an au-
thorized dealer to have it checked.
MAINTENANCE AND CLEANING OF THE HELMET
WARNING
- The helmet and its components may be seriously damaged by some common substances
without the damage being visible. Use only lukewarm water and mild soap for maintenance
and cleaning operations; dry at room temperature away from the sun and/or heat sources.
- Never use petrol, thinner, benzene, solvents or other chemical substances, paints, and adhe-
sives for maintenance and cleaning operations. These can irreparably damage the helmet and
its components, modify its optical properties, reduce its mechanical properties and weaken
the protective treatment of the visor and/or sunscreen that may be present in the helmet.
A
SAFETY AND INSTRUCTIONS FOR USE
N60-6
EN
13