Oscillo-Saw GOLD II Autopsy
For the manual cleaning use plastic brushes and /or cleaning pistols. Do not use cleaning agents
with fixing effect. The pH- value should be also <10, so that the surface coating won't be damaged.
Wash the saw head with fully demineralized water. Then use
disinfectant.
The preparation and sterilization is only allowed for the saw
Furthermore clean the cooling slots (see fig.5) to ensure sufficient ventilation for cooling the motor.
Clean the motor compartment from the outside with a jet of dry compressed air.
After the sterilization the construction takes place.
8 Sterilization
Only autoclave the saw head (gear part) in steam!
Do not autoclave the electrical motor. It should not come in contact with water, respectively
other liquids, or their steam.
Disassembly:
Remove the retaining screw, fixation ring and saw blade. Loosen the two Allen screws and unscrew
completely. Take off the saw head (gear part), it can now be autoclaved.
Reassembly:
Is done in reverse order. It is important to make sure that the wing is lightly greased with about 1ml HB
8877 before reassembly. Furthermore the screws must be tightened with 6 Nm.
Attention: Plugging the saw head to the motor is done by
pressing with slight back- and forth movements until the wing is
locked outside the groove ball bearing.
9 Accessories
HB 8899-01
Transportation case with insert
HB 8889-01
Retrofit kit (vacuum cleaner, hose, suction unit, tool), 220-240V
HB 8889-01V
Retrofit kit (vacuum cleaner, hose, suction unit, tool), 100-120V
HB 8878-01
Patent Screw
Round saw blade TITANIUM, 50 mm
HB 8895-03
Round saw blade, TITANIUM, 65 mm
HB 8896-03
Round saw blade "non-stick", 50 mm
HB 8895-04
Round saw blade, "non-stick", 65 mm
HB 8896-04
Round saw blade, 44 mm, for plaster
HB 8897-01
Round saw blade, 44 mm, x-bite
HB 8897-02
Round saw blade, 50 mm, for plaster
HB 8895-01
Round saw blade, 50 mm, x-bite
HB 8895-02
Round saw blade, 65 mm, for plaster
HB 8896-01
Round saw blade, 65 mm, x-bite
HB 8896-02
head! Not for the electrical motor!
EN
Fig. 11
HB 8893-01/-02
Autopsy saw blade
27