Loop Plumbing Diagram; Intellichlor Scg Plumbing Diagram - Pentair INTELLICHLOR IC15 Guía De Instalación Y Usuario

Loop Plumbing Diagram

®
The IntelliChlor SCG is designed to operate with water flow rates from 25 +/- 5 gallons per minute (gpm) up to
105 gpm. Refer to the pipe manufacturer specifications for recommended maximum flow rate. For flow rates
over 80 gpm you must use a bypass loop (as shown below) for best chlorine production. Installations with flow
rates over 80 gpm include those that have in-floor cleaning systems or booster pumps. These systems MUST
use a bypass loop with the IntelliChlor SCG with a flow control valve that assures that the flow through the
IntelliChlor SCG is maintained within its designed operating water flow rates.
Not to scale

IntelliChlor SCG Plumbing Diagram

Plumbing the IntelliChlor
• Always install the IntelliChlor SCG AFTER the filter and heater (see "System Schematic Diagram"
on page 4). The IntelliChlor SCG should be at least three (3) feet away from the heater outlet.
• If the IntelliChlor SCG is installed on a pool/spa combination system, install (see diagram below) the
IntelliChlor SCG BEFORE the pool/spa return valve to allow proper chlorination of both the pool
and spa and also to avoid creating gas being traped in the pool plumbing.
Note: For best flow
sensing, provide at least
12"-18" of straight pipe in
front of the cell inlet.
IntelliChlor SCG System Loop Plumbing Diagram
®
Salt Chlorine Generator:
IntelliChlor SCG System Plumbing Diagram
®
IntelliChlor Salt Chlorine Generator Installation and User's Guide
Note: Install IntelliChlor
SCG cell vertically for best
performance.
NOT TO SCALE
5