Connecting Intellichlor Communication Cable (Rs-485) - Pentair INTELLICHLOR IC15 Guía De Instalación Y Usuario

WARNING - Switch OFF main system power to the Load Center before making any connections.
®
Connecting IntelliChlor SCG Communication Cable (RS485):
1. Unlatch the load center/power center enclosure door spring latch, and open the door.
2. EasyTouch ® / IntelliTouch
panel.
(a) Lower down the control panel on its hinges to access the motherboard located behind the
control panel.
(b) Route the four conductor cable up through the low voltage raceway in the load center to the
motherboard.
Note: For SunTouch
3. Strip back the cable conductors ¼ in. Insert the wires into the connector screw terminals (provided
in the kit). Secure the wires with the screws. Make sure to match the color coding of the wires;
Red = +15, Yellow = +DT, Green = -DT, and GND = Black.
4. Insert the connector screw terminal onto the COM Port pins on the circuit board: (EasyTouch
J20, IntelliTouch J7/8).
7. When the connection is completed: EasyTouch/IntelliTouch: Close the control panel and secure it
with the two (2) retaining screws.
8. Close the load center front door. Fasten the spring latch.
COM PORT
(J20)
Indoor Control Panel
IntelliChlor
IntelliFlo
RF Transceiver
EasyTouch Control System Circuit Board
Note: EasyTouch or IntelliTouch Control System Load Center
For information about connecting an IntelliChlor SCG to an EasyTouch or
IntelliTouch Control System Load Center with built-in IntelliChlor SCG power
supply, please refer to the EasyTouch or IntelliTouch Pool and Spa Control
System (with optional IntelliChlor Salt Chlorine Generator) Load Center
Installation Guide (P/N 521139)
® Control System: Loosen the two (2) retaining screws from the control
®
Control System see page 26 for details.
IntelliChlor
COM ports
BLK
GRN
YEL
RED
IntelliTouch Control System Personality Circuit Board
®
Salt Chlorine Generator Installation and User's Guide
25
Personality board
(Connector J7 or J8)
9.