Section 1: Intellichlor Scg Control Panel; Salt Level Status Leds; Status Leds - Pentair INTELLICHLOR IC15 Guía De Instalación Y Usuario

Salt Level Status LEDs

The IntelliChlor SCG checks the pool salinity water daily and displays the
levels as follows:

Green LED: Good salt. The pool water salt level is between 2800
ppm and 4500.
Green LED (Flashing): Salt level is above 4500 ppm. The salt level
is high which increases the risk of corrosion and deterioration of pool
equipment and surfaces in and around the pool.

Red LED: Low salt. The water salt level is below 2800 ppm. The
IntelliChlor SCG will be producing chlorine at reduced efficiency. It is
highly recommended to add salt. See (*) Note below.
Red LED: Very low salt . The water salt level has fallen below 2600
ppm. The IntelliChlor SCG will not produce chlorine until salt is
added. The IntelliChlor SCG is OFF. See (*) Note below.
NOTE (*): After every salt addition, pump should be allowed to
run for at least 24 hours for proper dilution. Salinity readings
should only be taken, after the dilution period.

Status LEDs


Cold Water: Shows the IntelliChlor SCG power status:
• No Light: The IntelliChlor SCG is operating in the normal
temperature range (> 52° F (11° C)
• Red: The IntelliChlor SCG is in "Standby" mode (system off,
no chlorine production) due to a cold water condition. The
IntelliChlor SCG will resume to normal operation mode,
including accurate salinity report, once water temperature
goes above 52° F (11° C).

Cell: Shows the status of the IntelliChlor SCG.
• Green (flashing): The IntelliChlor SCG needs to be
inspected. The blades may have calcium buildup. The
IntelliChlor SCG is not producing chlorine.
• Green: IntelliChlor SCG is good and producing chlorine
No Light: IntelliChlor SCG is off and not producing chlorine.
It may be in an off-period of the sanitizing cycle and will
return on shortly.

Flow: This light indicates the status of water flowing through the
IntelliChlor SCG.
• Red: Insufficient water flow through the IntelliChlor SCG, no chlorine is being produced.
• Green: Sufficient water flow to produce chlorine.

Sanitizer Output LED indicators: See page 8.

Less / More Buttons: Controls the percentage of the total output capacity that the IntelliChlor SCG is
producing while the pump is on (see Sanitizer Output LED indicators above). See page 8.
IntelliChlor
®
IntelliChlor Salt Chlorine Generator Installation and User's Guide
Section 1
®
SCG Control Panel







7