A&D Medical UM-212BLE Manual De Instrucciones página 41

Measuring using the AOBP mode
Select AOBP mode by setting measurement conditions of "AOBP mode
setting (Multiple measurement )" to enable AOBP mode measurement.
If this device enters standby mode, it automatically returns to normal
measurement mode from AOBP mode.
Setting example
Measurement count
Rest time
Measurement interval
1. Wrap the cuff on the arm.
In measurement, sit in rest.
2 Select AOBP mode by using the MODE button
to display
3 Press the START/STOP button to start
countdown for the rest time.
4
Note: When the blood pressure value cannot be
obtained properly, this device
automatically performs re-inflation.
When you wish to avoid re-inflation,
perform the measurement after setting the
re-inflation value properly.
Refer to "Measurement with the SET
Pressure" for details.
To stop pressuring, press the
START/STOP button again.
5 After ending the measurement, the air
remaining in the cuff is automatically exhausted.
isplay shows each measurement result of
the systolic pressure value, diastolic pressure
value and pulse rate.
Countdown for the measurement interval starts.
average value
"F17-1"
"F17-2"
"F17-3"
mark.
display shows results for the
.
E n
: 3 times
: 3 minutes
: 1 minute
g s i l h 3 9
AOBP