Fm Radio; Operating Your Radio - Search Tuning Fm - Sangean DDR-43+ Manual De Instrucciones

Operating your radio - Search tuning FM

1. Fully extend the telescopic aerial.
2. Press the On / Standby button to switch on your sound system.
3. Press and release the Radio button until the FM band is selected.
4. Press and release the Auto-tune button to cause your radio to scan in
the direction previously scanned and stop automatically when it finds
a station of sufficient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. To find additional stations press and release the Auto-tune button
as before.
7. To scan the FM band in a opposite direction press and release either
the Up Tuning button (to scan low frequency to high frequency) or the
Down Tuning button (to scan high frequency to low frequency) and
then press the Auto-tune button again.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end.
9. Adjust the Volume to the required setting.
10. To switch off your radio press the On / Standby button.
GB
19