ROBLIN CLARITY 480 Instrucciones De Montaje página 10

GB GB
UK ELECTRICAL CONNECTION - ELECTRICAL REQUIREMENTS
FUSE
FUSE FUSE
Any permanent electrical installation must comply with the lastet I.E.E Regulations and local Electricity Board regulations.
For your own safety this should be undertaken by a qualified electrician e.g. your local Electricity Board, or a contactor
who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC).
Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating inside the
cooker hood.
This appliance is fitted with a 2 core mains cable and must be permanently connected to the electricity supply
via a double-pole switch having 3mm minimum contact gap on each pole.
A switched Fuse Connection Unit to BS.1363 Part 4, fitted with a 3 Amp fuse, is a recommended mains supply connection
accessory to ensure compliance with the Safety Requirements applicable to fixed wiring instructions.
The wires in this mains lead are coloured in accordance with the following code :
Green & yellow :
Blue :
Brown :
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying
the terminals in your connection unit, proceed as follows :
The wire which is coloured blue must be connected to the terminal which is marked with the letter 'N' or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter 'L' or coloured red.
ON
ON ON
Earth
Neutral
Live
BLUE (NEUTRAL)
L supply
N
DP
N Supply
GREEN & YELLOW
(EARTH)
BROWN (LIVE)
L