Maintenance; Remote Control Battery Replacement; Cleaning; Servicing - Dimplex XLF50 Guía De Instalación Y Del Usuario

Maintenance

Remote Control Battery Replacement

To replace the battery:
1. Slide battery cover open on the remote control.
2. Correctly install one 3 Volt (CR2032 [longer life] or CR2025) battery in the battery holder with the + side facing up.
3. Close the battery cover.
The battery must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling
advice in your area.
WARNING: Disconnect power and allow heater to cool before attempting any maintenance or cleaning to
reduce the risk of fire, electric shock or damage to persons.

Cleaning

Mirrored Glass Cleaning
The mirrored glass is cleaned in the factory during the assembly operation. During shipment, installation, handling,
etc., the mirrored glass may collect dust particles; these can be removed by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the mirrored glass can be cleaned with a damp cloth. The mirrored glass
should be completely dried with a lint-free cloth to prevent water spots. To prevent scratching, do not use abrasive
cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the fireplace. Do not use abrasive cleaners.
The fireplace should not be operated with an accumulation of dust or dirt on or in the unit, as this can cause a build-
up of heat and eventual damage. For this reason the heater must be inspected regularly, depending upon conditions
and at a minimum yearly intervals.

Servicing

Except for installation and cleaning described in this manual, an authorized service representative should perform
any other servicing.
20 www.dimplex.com