Top Control Panel - Shark HP100EU Manual De Instrucciones

Your air purifier is equipped with a control panel on the top of the unit and a display screen on the front of the unit.

TOP CONTROL PANEL

Includes controls that allow you to customise the settings.
FRONT DISPLAY SCREEN
Displays the current air quality status based on the Air Info mode
selected on the top control panel.
The built-in sensor detects your air quality to give you real-time information. Use the AIR INFO button to switch between air quality display
options.
INFO
% AIR QUALITY
TIME REMAINING
PARTICLE SIZES
PM1
MAX
PM2.5
MAX
PM10
AIR INFO SETTINGS
FRONT DISPLAY
SCREEN
The PM (particulate matter) value is the amount of particulate in your air, measured in micrograms
MAX
(μg) per cubic meter. Your air purifier measures three particle sizes, PM1, PM2.5, and PM10.
Displays the amount of PM1-sized particles in your air, including viruses and ultra-fine allergens.
CONTROL PANEL
MAX
TOP CONTROL PANEL BUTTONS
On/Off: Press to turn the power on or off.
Air Info: Press to switch between air quality display options.
See the Air Info Settings section for more information.
Auto Mode: Press to turn on Auto Mode. In this setting the
MAX
fan speed automatically adjusts based on real time air quality
readings. As the air quality improves, the fan speed will
decrease. If air quality worsens, the fan speed will increase.
Leave your unit in Auto Mode for optimal performance.
Filter Life: Press to show the remaining filter life.
Once the filter has 0% remaining, the FILTER LIFE button
will flash to indicate the filter needs to be changed. See
Installing and Removing the Filter section for more information.
Brightness: Adjusts the brightness of both the front display
MAX
screen and the top control panel. Switch between 3 options:
full brightness, partially dim, fully dim.
Shut-Off Timer: Set the number of hours for the air purifier to
run before it automatically shuts off. Timer can be set between
1–12 hours.
Fan Speed: Adjusts the speed of the fan. Select one of 4 settings:
1 Low, 2 Medium, 3 High, 4 Maximum. Note: If fan speed is
manually changed, auto mode will be deactivated. For tips on
optimal fan setting, see Optimising Fan Speed section.
Optimise Performance in Eco Mode: After 100% clean air
status is achieved for 10 minutes in Auto Mode, your air purifier
will enter Eco Mode. Your unit's filter life and electricity usage will be
Optimised!
To control your unit's beeping, hold the Air Info and Child Lock
buttons at the same time for two seconds.
REAL-TIME READING
Displays the air quality rating:
• Poor: 0%–69% • Fair: 70%–84% • Good: 85%–100%
If your unit reads 100% this means your air quality is very good.
Should the air quality drop, the % will adjust accordingly.
Shows the estimated time remaining until reaching air quality rating- Good: 85%-100%
Displays the amount of PM2.5-sized particles in your air, including smoke and bacteria.
Displays the amount of PM10-sized particles in your air, including dust, mould, and pollen.
MAX
MAX