Shark HP100EU Manual De Instrucciones página 20

NOTE: Always remove all protective packaging from the filter before installing.
When the filter timer has 0% remaining, the FILTER LIFE button on the top control panel will blink, indicating that it's time to install a new
filter.
1. Turn off and unplug the unit before removing or installing filters.
2. Remove the filter door from the bottom of the unit by twisting
the filter door to the unlocked position and removing.
3. To remove the old filter, pull it out by the tabs at the top and
bottom of the filter (2). Discard old filter in rubbish bin.
4. Remove all packaging and wrapping from the new filter.
1
Disposing of used filters
Filters can't be cleaned or recycled. After removing a used filter, wrap it in an airtight plastic bag for disposal. As an extra precaution, wear
gloves when handling a dirty filter.
NOTE: Always unplug the unit before doing any cleaning or maintenance.
Exterior Cleaning:
For best results, clean the exterior of the unit every two months or
as needed. Use a microfibre cloth to remove dust. Wipe down the
exterior with a microfibre cloth dampened with warm, soapy water.
Avoid excess water and abrasive chemical cleaners to prevent
damage.
To maximise your air purifier's filter life, we recommend flipping
and rotating your filter every three months. This will help equalise
and balance the distribution of captured particles throughout the
filter allowing for extended usage.
INSTALLING AND REMOVING THE FILTER
5. Insert the new filter, then replace the filter door. Twist the filter
6. Plug the unit back in and turn on power. Calibration will begin.
7. After installing a new filter, press and hold the Filter Life button
2
MAINTAINING YOUR AIR PURIFIER
Interior Cleaning:
For best results, clean the interior of the unit every two months
or as needed. Remove the filter cover, take out the filter, and
use a vacuum cleaner or a microfibre cloth to remove dust and
debris from the interior of the unit. DO NOT use abrasive chemical
cleaners on the inside of the unit.
door until it clicks into place.
on the top control panel for 3 seconds to reset the filter life
percentage. The unit will beep when the filter life is reset to 100%.
3
Remove
filter
from
plastic
packaging