DeWalt DCS692 Manual De Instrucciones página 19

For assistance with your product, visit our website at www.dewalt.com for a list of service centers, or call D
1‑800‑4‑D WALT (1‑800‑433‑9258).
e
PROBlEM
Machine will not start.
Machine shuts off abruptly.
Reduced run time.
Battery pack will not charge.
Frayed edges or tears on the
cutting wheel.
Cutting wheel wanders off the
cutting line.
Wear on the side of the cutting wheel. Surface grinding.
Reduced or no cutting performance.
Chipping or cracking in the
wheel core.
Sparking.
Heavy load indicator LED illuminated.
TROUBLESHOOTING
BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
POssiBlE CAUsE
Battery pack not installed properly.
Battery pack not charged.
Battery pack too hot/cold.
Internal components too hot.
Battery pack has reached its maximum
thermal limit.
Out of charge. (To maximize the life of the
battery pack it is designed to shut off
abruptly when the charge is depleted.)
Battery is not completely charged.
Life of the battery has been reached.
Battery pack not inserted into charger.
Charger not plugged in.
Surrounding air temperature too hot or too cold. Move charger and battery pack to a surrounding air
Cutting wheel wobbling.
Cutting wheel is blunt.
Built‑up edges on the cutting wheel.
Cutting wheel wobbling.
Cutting wheel is blunt.
Cutting wheel is not properly installed.
Cutting wheel is blunt.
Built‑up edges on the cutting wheel for stone.
Cutting wheel is not properly installed.
Cutting material for which the cutting wheel
is not rated.
Overload.
Built‑up edges on the cutting wheel for stone.
Too much force on the tool.
sOlUTiOn
Check battery pack installation.
Check battery pack charging requirements.
Allow battery to cool down or warm up.
Allow machine to cool down.
Allow battery pack to cool down.
Place on charger and allow to charge.
Charge battery.
Replace with a new D WALT FLEXVOLT™ battery.
e
Insert battery pack into charger until LED illuminates.
Plug charger into a working outlet. Refer to Important
Charging Notes for more details.
temperature of approximately 65 °F – 75 °F (18 °C– 24 °C).
Replace with a new cutting wheel.
Replace with a new cutting wheel.
Dress the cutting wheel by briefly cutting in abrasive material.
Replace with a new cutting wheel.
Replace with a new cutting wheel.
Mount cutting wheel correctly. Refer to Installing Abrasive
and Diamond Wheels.
Do not surface grind with the cutting wheel.
Replace with a new cutting wheel.
Dress the cutting wheel for stone by briefly cutting in abrasive
material. Use a new cutting wheel for cutting asphalt.
Mount cutting wheel correctly. Refer to Installing Abrasive
and Diamond Wheels.
Use the proper cutting wheel.
Replace with a new cutting wheel.
Dress the cutting wheel for stone by briefly cutting in abrasive
material. Use a new cutting wheel for cutting asphalt.
Reduce force.
English
WALT at
e
17