Installing The Child Seat - Boston ECE R44/04 Instrucciones De Uso

EN

1. INSTALLING THE CHILD SEAT

INSTALLATION from 9 kg up to 18 kg (76-105cm):
1a Slide the lso x anchors B
maximum length by turning the lever A (17). Do
this on both sides of the seat.
Open the cover
connector out (4).
1b Connect the lso x anchors until you hear them
click into place. The display window on the button
(15)
will turn from red to green. Push the seat as far
back as possible. Make sure that both lso x are in
the same position once you have pushed the seat
back.
1c Connect the Top Tether in the anchor
point intended for this in the vehicle
marked with the symbol:
12
Lastly, tighten the strap of the TT system
until the green signal is displayed on the indicator.
The strap should go over the backrest of the
vehicle seat. If necessary raise the headrest or
remove it.
(5) to their
(16) and take the top tether
The connector may be closed without being
secured in the ISOFIX anchor. Please make sure that
the connectors are correctly fastened into the
anchor points of the vehicle by pulling the seat
once it hasbeen installed.
To detach the seat follow the same steps in reverse:
(15)
Move the button to open the connector and
release the anchors.
INSTALLATION from 15 kg up to 36 kg (105-135cm):
Follow the same steps as before 1a， 1b. In this case
you should not connect the Top Tether.
There is also the possibility of installing the seat
only with the car seat belt.