Safety Instruction - Sharp PN-HE751 Manual De Instalación

SAFETY INSTRUCTION

- Do not use the monitor where there is a lot
of dust, where humidity is high, or where
the monitor may come into contact with oil
or steam. Do not use in an environment
where there are corrosive gases (sulfur
dioxide, hydrogen sulfide, nitrogen
dioxide, chlorine, ammonia, ozone, etc.).
As this could lead to fire.
- Ensure that the monitor does not come
into contact with water or other fluids.
Ensure that no objects such as paper clips
or pins enter the monitor as this could lead
to fire or electric shock.
- Do not place the monitor on top of
unstable objects or in unsafe places. Do
not allow the monitor to receive strong
shocks or to strongly vibrate. Causing the
monitor to fall or topple over may damage
it.
- Do not use the monitor near heating
equipment or in places where there is
likelihood of high temperature, as this may
lead to generation of excessive heat and
outbreak of fire.
- Do not use the monitor in places where it
may be exposed to direct sunlight. Risk
of cabinet deformation and failure if the
monitor is used in direct sunlight.
- Please be sure to constantly remove dust
and garbage that has attached to the
ventilation opening. If dust collects in the
ventilation opening or the inside of the
monitor, it may lead to excessive heat,
outbreak of fire, or malfunction.
Please request a cleaning of the inside of
the monitor from an authorized SHARP
servicing dealer or service center.
- The power outlet shall be installed
near the equipment and shall be easily
accessible.
- This monitor should be used at an
ambient temperature between 32°F (0°C)
and 104°F (40°C). Provide enough space
around the monitor to prevent heat from
accumulating inside.
- Do not block any ventilation openings. If
the temperature inside the monitor rises,
this could lead to a malfunction.
- Do not place the monitor on a device
which generates heat.
- Please see the penultimate page for
additional information on mounting
precautions.
The Power Cord
- Use only the power cord supplied with the
monitor.
- Do not damage the power cord nor place
heavy objects on it, stretch it or over
bend it. Also, do not add extension cords.
Damage to the cord may result in fire or
electric shock.
- Do not use the power cord with a power
tap.
Adding an extension cord may lead to fire
as a result of overheating.
- Do not remove or insert the power plug
with wet hands. Doing so could result in
electric shock.
- Unplug the power cord if it is not used for
a long time.
- Do not attempt to repair the power cord
if it is broken or malfunctioning. Refer the
servicing to the service representative.
6