Symbols; Operating Instruction - MaxPro PROFESSIONAL MPER2000/12VGC Manual

can reduce the risk of injury.
•Accidental c
before it is connected with power supply or storage ba ery and before it is li ed or moved. If fingers touch
the switch or the disconnected tools are connected with power supply during the moving process of the
electric tools, unfortunate accidents may happen.
•Before the electric tool is connected, all adjustment tools and nut wrench of it shall be taken down first. If
unfixed nut wrench and adjustable wrench fall into rolling parts, they will cause harm.
•The device shall not be dragged and shall be kept in stable
thus can be be er controlled in unpredictable situa
•Dressing shall be standard without loose clothes or accessories. Your hair, clothes and gloves shall always
be away from rolling parts because loose clothes, accessories or long hair may be drawn into the moving
parts of the device.
•If there are devices which can be used to connect with dust collectors or dust exhausters, they must be
guaranteed to be connected and used correctly. The use of dust collectors can reduce the risk probability
that is related with dusts.
•When machines are in normal opera
not touch them un
SPECIAL SAFETY RULES OF ELECTRIC ROUTER
1. Tools shall be picked up and put down very carefully.
2. Tools shall be carefully examined whether there are cracks or damage before they are operated, and
tools with cracks or damage shall be r
3. Nails shall be avoided to be cut. Workpieces shall be examined and all nails shall be taken away before
the work.
4. Device shall be gr
5. Hands shall always be away from rolling parts.
6. Switches of tools shall be turned on before tools are guaranteed not to be connected with workpieces.
7. Workpieces shall be observed whether there are drives because of the bad installa
running for a while before they are actually processed.
8. Dir rota
9. Time beyond the opera
10. A er power supply is turned off and tools completely stops, workpieces can move the machines.
11. Workpieces shall not be touched immediately a er the processing because tools are too hot to scald
the skin.

SYMBOLS

Read the manual
Warning

OPERATING INSTRUCTION

Before commencing work, check that the tool housing automatically rises to the maximum height and
of the device is not allowed. Electric tool shall be guaranteed to be in off state
or abrasive discs are rota
stop running to avoid injury.
htly by both hands.
feed-in of t
controlled by hands without making machines run brokenly.
and balance during the use, which
g, hands or other parts of body shall
Wear dusk mask
Do not dispose of old appliances in the
household garbage
Keep your hands and feet away from all
opening
GB
of tools by blank
3