Cleaning And Maintenence; Environment; Trouble Shooting - MaxPro PROFESSIONAL MPER2000/12VGC Manual

Replacing the carbon brush
1. Maximum abrasion marking
Regularly remove the carbon brushes and conduct a visual inspection.
a) Replace the carbon brushes when the amount of wear reaches the maximum abrasion marking. Keep the
brushes clean and ensure that they can move freely in the brush holder. Both carbon brushes should be
replaced at the same time. Only use carbon brushes provided by the manufacturer.
1. Carbon brush cover 2. Screwdriver
a) Use a screwdriver to remove the brush cover. Remove the used carbon brushes. Insert the new brushes
and secure the cover in place.
After replacing the carbon brushes, connect the tool to the power supply and let it run idle for
approximately 10 minutes. When the tool is running, check that it is operating normally and release the
on/off trigger to check that the electric brake is working.
CLEANING AND MAINTANCE
CAUTION! B efore performing any care or maintenance work, disconnect from the power.
Use a dry brush to clean the dust extrac
not use solvents! Then dry well. Remove the dust c
carefully, try not to create dust. Do not breathe in saw dust! Wash out the bag in cold soapy water and
allow drying.
Before each use, check the machine, the cable and accessories to ensure that they are not damaged. Have
any necessary repairs completed by a specialist.
Machines that no longer fu
regula

ENVIRONMENT

Do not dispose of electric tools, accessories and packaging together with household waste material -
in observance of European Dir
implementa cordance with na
be collected separately and returned to an environmentally compa

TROUBLE SHOOTING

Fault phenomenon
Motor doesn't work.
Motor starts slowly and can't
reach the opera
openings. Clean the housing with a damp cloth only – do
on properly should be disposed off correctly in accordance with the local
ve 2002/96/EC on waste of electric and electronic equipment and its
aw, electric tools that have reached the end of their life must
Possible cause
Plug isn't in the socket of power
supply.
Power supply is disconnected.
Switch is not turned on or
c switch is not good.
Stator or outgoing line burns out.
Shield of handpiece isn't covered
well, which causes the inter switch
off.
Joint of c
Parts of machine jam.
GB
bag from the plas
recycling facility.
Elimina
Plug it in the socket of power supply.
Check and connect power supply.
Turn on the switch or ask
professional to fix and replace
switch.
Ask professional to replace stator
and weld again.
Please close the shield again.
reaks. Ask professional to check joint of
c
Ask professional to check
mechanical parts.
to empty. Empty
ethod
5