MSW -PG2200 Manual De Instrucciones página 33

The unit is delivered almost ready, and only the wheels and the feet need to be
mounted (see above pictures).
First, put the wheel with the protruding part of the rim on the unthreaded side of
the axle shaft, and on the other side secure the rim by first putting a washer on it
and then inserting a clip up to the head in the hole at the end of the axle shaft. Bend
the ends of the pin protruding from the other side of the hole around the axle to
protect
Repeat the operation for the second wheel. The wheels assembled in the way with
half-shafts should be fixed in the holes provided in the frame of the unit, securing
them from the inside of the unit with washers and flange nuts.
In order to assemble the feet, first fix the rubber stoppers to the U-shaped brackets
with 2
Then attach the feet prepared in such a way to the underside of the frame using
the 4 bolts and the appropriate flange nuts provided (2 for each foot).
the wheel
bolts
against
and flange
falling off.
nuts.