Ducting Options - Yale PCHBL630SS Guía De Instalación, Uso Y Mantenimiento

Parts no supplied
Tools/Materials required
• Level
• Drill
• 1 ⁄ " (3.2 cm), ⁄ " (3.2 mm), and
1 1
4 8
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Jigsaw or keyhole saw
• Metal snips
• Screwdrivers:
• Flat-blade
• Phillips

Ducting Options

Closely follow the instructions set out in this manual.
All responsability, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is
declined.
The hood is equipped with a 6" (15.2 cm) round transition for
discharge of fumes to the outside.
Roof Venting
A
B
A. Roof cap
B. 6" (15.2 cm) round vent
Preparation
Do not cut a joist or stud unless absolutely necessary. If a joist or
stud must be cut, then a supporting frame must be constructed.
Fittings material is provided to secure the hood to most types of
walls/ceilings.
However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
Recommended installation height:
Hood installation height above cooktop is the users preference.
The lower the hood is above the cooktop, the more efficient the
capturing of cooking odors, grease and smoke.
6
⁄ " (4.8 mm) drill bits
1
16
Ducting version
Wall Venting
B
A. Wall cap
B. 6" (15.2 cm) round vent
Optional accessories and consumable parts
KIT
Recirculating Kit
Long Chimney
Extension
In cases where it should not
be possible to discharge
cooking fumes and vapour to
the outside.
Attach a charcoal filter and
the deflector on the duct
cover support bracket.
Fumes and vapours are
recycled through the top
grille by means of a duct
A
connected to the transition
and the transition mounted
on the deflector.
For this version only:
purchase the Ductless
Recirculating Kit.
Minimum Duct Size:
6" Round Pipe.
CAUTION
For gas cooktop & range installations: mount the hood so the
bottom is at list 30" (76.2 cm) above the cooking surface.
For electric/induction cooktop & range installations: mount the
hood so the bottom is at least 27" (68.58 cm) above the cooking
surface.
There is no maximum mounting height, however, we recommend
mounting the hood no greater than 36" (91.4 cm) above the
cooking surface. For every inch (2.54 cm) above 36" (91.4 cm),
fume and moisture capture efficiency diminishes at an increasing
rate and may not deliver an acceptable level of ventilating
performance. This hood is intended for household use.
PLEASE READ THE INSTALLATION MANUAL FOR SPECIFIC
APPLICATION. Check your ceiling height and hood height
before selecting your hood.
# Part
ACC02766
ACC02762
Ductless (Recirculating)
B
A. Deflector
B. 6" (15.2 cm) round vent
A