EAS ELECTRIC EMCF153 Manual De Instrucciones página 29

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Trouble shooting
You may try to solve the following simple problems by yourself. lf they
cannot be solved, please contact the after-sales department.
Failed
operation
Smell
Long-time
operation of
the compressor
Light fails
to get lit
Doors cannot be
properly closed
Loud noise
Transient
difficulty in
door opening
Freezer
enclosure heat
Condensation
Abnormal
noises
Check whether the appliance is connected to power or
whether the plug is in well contact
Check whether the voltage is too low
Check whether there is a power failure or partial
circuits have tripped
Odorous foods shall be tightly wrapped
Check whether there is any rotten food
Clean the inside of the refrigerator
Long operation of the freezer is normal in summer
when the ambient temperature is high
lt is not suggestible having too much food in the
appliance at the same time
Food shall get cool before being put into the appliance
The doors are opened too frequently
Thick frost layer (defrost is needed)
Check whether the freezer is connected to power
supply and whether the illuminating light is damaged
Have the light replaced by a specialist
The door is stuck by food packages
Too much food;
Unbalanced freezer
Check whether the floor is level and whether the
freezer is placed stably. Check whether accessories are
placed at proper locations
After refrigeration, there will be pressure difference
between the inside and outside of the freezer to
result in transient difficulty in door opening. This is a
normal physical phenomenon.
The freezer enclosure may emit heat during operation
specially in summer. This is cause by the radiation of
the condenser and it is a normal phenomenon.
Condensation on the exterior surface and door seals of
the refrigerator is normal when the ambient humidity is
too high. Just wipe the condensate with a clean towel.
Refrigerants circulating in the refrigerant lines will
produce eruption of sound and grunts which is normal
and does not affect the cooling effect.
Buzz will be generated by running compressor, specially
when starting up or shutting down. The solenoid valve
or electric switch valve will clatter, which is a nomal
phenomenon and does not affect the operation.
14
V.1

Publicidad

Tabla de contenido
loading

Tabla de contenido