Sanus Systems VMSA Instrucciones De Armado página 3

Assembly Instructions for Model: VMSA
Thank you for choosing a Sanus Systems Vision Mount wall mount. The VMSA is designed to mount up to 50" Flat panel televisions
weighing up to 150 lb. to a vertical wall. It allows you to tilt the television from +5° to -15°. It will also extend 9.5" away from the wall,
swivel up to 30°, and roll ± 6°.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a quali-
installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be
shipped directly to you. Check carefully to make sure that there are no missing or defective parts. Never use defective parts. Improper
-
tems. Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please
call Sanus Systems before returning products to the point of purchase.
Note: The supplied wall mounting hardware is not for metal stud, concrete, brick, or block walls. If you are uncertain about the nature of
your wall, consult an installation contractor. Sanus makes every effort to assure all necessary television mounting hardware is included.
If the hardware you need is not included please consult your local hardware store or call Sanus Systems.
Required Tools: 3/16" drill bit, wrench set, phillips screw driver
Supplied Parts: Some parts not shown at same scale *
(1) Wall Plate - a (1) Arm Assembly - b
*