Sanus Systems VMSA Instrucciones De Armado página 7

Step 3: Add the Vise Assemblies to the Monitor Brackets:
Note: Do not overtighten the 1/4-20 Nut (cc). The Vise Assembly (e) should be able to rotate freely around the Car-
riage Bolt (bb).
Detailed View
Diagram 3
jaws e
bb cc
Step 4: Attach the Wall Plate: Wood Stud mounting options only.
Warning: DO NOT OVERTIGHTEN THE LAG BOLTS! Tighten Lag Bolts (i) only until the Lag Bolt Washer (j) is pulled
Wood Stud Mounting: The Wall Plate (a) must be mounted to two wood studs at least 12" apart. Use a high quality stud
sensor to locate two adjacent studs. It is a good idea to verify where the studs are located with an awl or thin nail as shown in Diagram
Diagram 4a Diagram 4b
i j a