Grounding Instructions - Uline H-5779 Instrucciones De Montaje

ATTACHING HEATER TO WALL MOUNT
1. The heater support bracket is attached to the heater
head assembly.
2. Attach heater support bracket to wall mounting
bracket using three 10 mm Allen bolts and three
nuts. (See Figure 2)
Wall Mounting
Bracket
Figure 2

GROUNDING INSTRUCTIONS

This heater is for use on a properly grounded, 120 volt
outlet. The cord has a plug as shown in Figure 3. An
adapter as shown at C is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet. The
adapter should not be used if a three-slot grounded
receptacle is available. (See Figure 3)
OPERATING THE HEATER
1. Plug power cord into 120V AC power outlet.
2. Use pull cord to turn heater power on and off.
WARNING! Always disconnect heater from
power supply before servicing.
WARNING! Risk of burns. This heater is hot while
operating. Allow to cool completely before
performing maintenance or storing.
WARNING! When servicing or replacement of a
component in the heater requires the removal
or disconnection of a safety device, that safety
device must be re-installed properly before
operating the heater.
PAGE 2 OF 9
HEATER INSTALLATION
Heater Support Bracket
(Attached to Heater)
MAINTENANCE
NOTE: The mounting bracket is designed to
support the weight of the heater only. Do not
hang any object other than the heater from
the wall mounting bracket, swivel arms or
support bracket.
WARNING! Do not mount the heater on the
ceiling. Mount only as described previously to
a 2 x 4" wall stud.
OPERATION
Figure 3
CLEANING
1. Clean the outer shell of the heater with a soft cloth
and allow to dry completely before operating
heater.
2. Do not use abrasives, rough brushes or scrubbing
pads to clean the heater.
WARNING! Fire or explosion may occur. Do not
use alcohol, gasoline, furniture/metal polish or
any other flammable substance to clean this
heater.
NOTE: Use compressed air to clean any dirt or
debris from the front guard or around the bulb.
Grounding Methods
C
Metal Screw
B
A
Cord
Grounding Pin
Grounding Means
0521 IH-5779