Operation - Dexter 450ETC1 Manual De Instrucciones

7. OPERATION

ON/OFF SWITCH
WARNING! Before starting:
• Ensure that there are no visible defects.
• Ensure that there is nothing in the work area that may hamper the work to be performed.
• Ensure that there is sufficient cooling water.
• Ensure that the guard is correctly mounted.
• Ensure that no one other than the operator is in the working area.
• For safety reasons replace the tool if it is found to be damaged in any way.
• To switch on, press the "I" on the on/off switch.
• Before you begin cutting, wait until the cutting wheel has reached maximum speed and wait for the
cutting disc to get wet.
• To switch off, press the "O" on the on/off switch.
• Pre-cut 2cm at the end side for better cutting surface.
TO MAKE A CROSS CUT
Cross cuts are straight 90° cuts. The material is fed into the cut at a 90° angle to the cutting disc.
• Using a marker or grease pencil, mark the area to be cut on material.
• Adjust parallel guide to desired position and push down the locking lever to secure it.
• Place the material on the table and firmly against the parallel guide.
• Make sure the material is clear of the cutting disc before turning on the saw.
• Turn the on/off switch to the on position.
• Let the cutting disc get up to full speed and wait for the cutting disc to get wet before moving the
material into the cutting disc.
• Hold the material firmly against the parallel guide and feed the material into the cutting disc.
• When the cut is made, turn the saw off. Wait for the cutting disc to come to a complete stop before
removing any part of the material.
TO MAKE A 45° DIAGONAL CUT
45° diagonal cuts are also referred to as "TO MAKE A CROSS CUT".
• Using a marker or grease pencil, mark the area to be cut on material.
• Set the parallel guide to desired width, and push down the locking lever to secure in place.
• Push the straight edge of the diagonal cut guiding device against the parallel guide.
• Make sure the material is clear of the cutting disc before turning on the saw.
• Turn the on/off switch to the on position.
• Let the cutting disc build up to full speed and wait for the cutting disc to get wet before moving the
material into the cutting disc.
• Hold the material firmly against the diagonal cut guide device and slide diagonal cut guide device
along parallel guide. Feed the material into the cutting disc.
• When the cut is made, turn the saw off. Wait for the cutting disc to come to a complete stop before
removing any part of the material.
TO MAKE A BEVEL CUT
Beveled 0°-45° cuts can be made tilting the table.
• Using a marker or grease pencil, mark the area to be cut on material.
• Loosen two locking knobs (one on the front and one on the back).
• Tilt the table to the desired angle, use the angle scale, and tighten two locking knobs.
• Set the parallel guide to desired width, and push down the locking lever to secure in place.
• Turn the on/off switch to the on position.
• Let the cutting disc get up to full speed and wait for the cutting disc to get wet before moving the
material into the cutting disc.
• Hold the material firmly against the 45° vertical fence and feed the material into the cutting disc.
• When the cut is made, turn the saw off. Wait for the cutting disc to come to a complete stop before
removing any part of the material.
• Tilt the table to 0° angle when finish the cutting.
116
FR
ES
PT
IT
EL
PL
UA
RO
EN