Operation; Inserting/Removing The Battery - Parkside PLHLA 20-Li A1 Traducción Del Manual De Instrucciones Original

GB IE
secured properly. There
is a risk of injury if the
device falls down.
• The light source of this
device is not replace-
able. If the light source
has reached the end of
its life, then the whole
device must be re-
placed.
• The luminaire housing
protects against acci-
dental contact with ac-
tive parts. Do not open
the housing.
Service
• Have your power tool
serviced by a qualified
repair person using only
identical replacement
parts. This will ensure
that the safety of the po-
wer tool is maintained.
Special safety direc-
tions for battery-ope-
rated tools
Ensure that the device
•
is switched off before
inserting the battery.
Inserting a battery into
16
a power tool that is
switched on may result
in accidents.
• Do not use any accesso-
ries that are not recom-
mended by PARKSIDE.
This can result in
electric shock or fire.
Observe the safety
information and
notes on charging
and proper use as shown
in the instruction manual
for your battery and char-
ger from the Parkside
X 20 V TEAM series. A de-
tailed description of the
charging process and fur-
ther information can be
found in the separate ope-
rating instructions.

Operation

Inserting/removing
the battery
1. To insert the battery (5),
place it on the guide track
and push it back into the ap-
pliance. It will audibly snap
in.
2. To remove the battery (5)
from the appliance, press the
release buttons (6) on the bat-
tery and pull out the battery.