Grabo OTTOVAC Manual De Instrucciones página 13

n. Follow all charging instructions and
do not charge the battery or tool
outside the temperature range
specified in the instructions.
Charging improperly or at
temperatures outside the specified
range may damage the battery and
increase the risk of fire.
6) SERVICE
a. Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power
tool is maintained.
b. Never service a damaged battery.
Service of battery should only be
performed by the manufacturer or
authorized service providers.
VACUUM LIFTING DEVICE
SAFETY WARNINGS /
INSTRUCTIONS
a. Do not deliberately try to rip the load
off with extreme force. There is a risk
of the load crushing feet and hands
and damaging the object and tool.
b. Do not lift objects weighing more
than 200 kg (440 lbs). There is a risk
the weight can fall off.
OTTOVAC | Operator's manual
c. Risk of load crushing feet and hands
and damaging the object and tool.
Do not shake the tool while lifting,
moving and placing objects. Do not
swing or shake the load while lifting,
moving and placing objects. Do not
use the tool when the seal is worn
out. Lift and carry the load with
uniform speed without sudden sharp
and strong movements.
d. Do not use the tool while the battery
is low. There is a risk of injury and
damage to the materials being lifted.
e. Do not attach the tool to surfaces
with visible puddles of water. Internal
components are not waterproof. If
water is sucked into the air ducts it
can cause permanent damage to the
tool. The OTTOVAC is not
waterproof and therefore extreme
caution should be taken when using
it in the rain or wet conditions.
f. Do not drop the tool from heights
above 1.5 meter above the ground
(chest level). If dropped by accident,
inspect the OTTOVAC for damage.
g. Do not place heavy objects on top of
the tool.
h. To avoid overheating, do not cover
the tool.
i. Ensure the power ON/OFF button is
in the off position before
transporting the tool and when in
storage. Be mindful that the tool is
not switched on accidently.
13