Black and Decker HSMC1300FX Manual De Instrucciones página 11

PROBLEM
• Unit will not start.
• Mop will not make steam. • No water in water tank.
• Mop leaves water on floor. • Cleaning pad is too wet. • Unplug unit from power outlet
• Mop left spot on floor.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACK+DECKER help line at 1-800-544-6986.
TROUBLESHOOTING
POSSIBLE CAUSE
• Cord not plugged in.
• Main switch not on.
• Floor head not correctly
fitted.
• Handle not fitted
correctly.
• SmartSelect dial is
TM
not turned on.
• Circuit fuse is blown.
• Circuit breaker is tripped. • Reset circuit breaker. (If the
• Cord or switch is
damaged.
• SmartSelect dial is
TM
not turned on.
• SmartSelect dial is
TM
turned up too high.
• Mop left in one spot too
long.
• Hard water.
Imported by Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286
BlackandDecker.com
1-800-544-6986
POSSIBLE SOLUTION
• Plug appliance into a working outlet.
• Turn main switch on.
• Ensure floor head is correctly
attached.
• Fit Handle correctly
• Turn SmartSelect
setting.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a BLACK+DECKER
service center or authorized
servicer.)
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a
BLACK+DECKER service center or
authorized servicer.)
• Have cord or switch replaced
at a BLACK+DECKER Service
Center or Authorized Servicer.
• Add water to the water tank.
• Turn SmartSelect
setting.
and change the micro-fiber
cleaning pad.
• Adjust SmartSelect
the amount of steam
being produced.
• Never leave the steam mop on
the floor with a damp or wet
cleaning pad still attached when
not in use.
• Use distilled water.
English
dial to desired
TM
dial to desired
TM
dial to reduce
TM
9