English
Owner´s manual
•
Multifunction control panel
From the digital control panel you can also consult the following information: battery voltage, working
hours, the serial number of the device...
Connect battery
WARNING!
The olive shaker is powered by a standard 12V car battery. To have a correct autonomy in a productive
day of eight hours, it is recommended that the battery has a minimum capacity of 80-100Ah.
To splice the connector of the tiller to the connector of the power cable you must use the two terminals
of the cable to connect the battery as follows:
Red terminal to positive pole (+)
Black terminal to negative pole (-)
WARNING!: Follow these instructions to avoid injury and reduce the risk of electric shock or fire:
- Replace the battery or power cord if damaged.
- Verify that the battery is disconnected before inspecting, adjusting or servicing any part of the tiller.
- Read, understand and follow instructions.
Extension assembly:
1. Turn off the machine, unplug the electrical part.
2.- Loosen the locking handle located at the end of the arm.
3.- Pull out the inner support tube from the arm.
4.- Insert the extension until it stops.
5. Close the locking handle again.
22
Switching the machine on/off
1. Plug in the cables and connectors to the battery.
2. To turn on or off press the power button for a few
seconds.
3. To start the device, go into the speed menu and press
the ON button again.
To increase or decrease the speed:
1. Enter the speed menu. 2.
2. Move up or down with the buttons to choose the
desired speed among the 5 available speeds (950 - 1000
- 1050 - 1100 - 1200 rpm).