FONESTAR ZS-2000M Manual De Instrucciones página 11

Connecting the Sound Source Equipment to the ZS-2000M or ZS- 4328IO
Connect the external sound source equipment to the ZS-2000M or ZS-4328IO appliance as necessary.
The sound source connected to the ZS-2000M will be used for broadcasting in this device zones .The
sound source connected to the ZS-4328IO will be used for broadcasting in the all zones of the system.
Figure 13 Schematic Diagram of Connecting the ZS-2000M External Sound Source Equipment
Figure 14 Schematic Diagram of Connecting the ZS-4328IO External Sound Source Equipment
Connecting the ZS-2000M to the ZS-1500/ ZS-2250/ ZS-4125
Note: The ZS-2000M can be connected to the power amplifier in the following configurations:
- Connect the PA1/2 and PA2 port of the single-channel power amplifier to the ZS-2000M control
port using two twisted-pair cables, as shown in Figure 1.
- Connect the PA1/2 port of the two-channel power amplifier to the ZS-2000M control port using
one network cable. Refer to 1, Figure 2.
- Connect the PA1/2 and PA3/4 port of the four-channel power amplifier to the ZS-2000M control
port using two network cables, as shown in 1, Figure 3.
1. Connect the ZS-1500/ZS-2250/ZS-4125 RJ45 port to the ZS-2000M control port using the audio input
lines that are included in the package containing the ZS-1500/ZS-2250/ZS-4125, as shown in Figure 15.
Figure 15 Connecting the RJ45 Audio Cable to the ZS-2000M and ZS-1500/ ZS-2250/ ZS- 4125
- 11 -
EN