Installation Inspection; Manual Setting - FONESTAR ZS-2000M Manual De Instrucciones

Figure 38 The connection between the PSTN telephone system and Digital Public Address and Voice

INSTALLATION INSPECTION

This section describes conducting a series of inspections after completing the system installation procedure
so as to ensure that the installation was done correctly.
INSPECTION
Inspect the following items after installing the Digital Public Address and Voice Alarm System and before
turning the system on:
- Check if sufficient heat ventilation space is left above the ZS-1500/ ZS-2250/ ZS-4125 appliance.
- Check the protective grounding cables to make sure they were correctly connected.
- Check the connections of the power supply to which the power supply cables are connected.
- Check the connection between system components.

MANUAL SETTING

While the commissioning process, you can make some manual setting:
- Inquiring the device IP.
- Inquire the device ID.
- Recovery ZS-2000M to default IP.
- Impedance Calibration.
INQUIRING THE DEVICE IP
- Press the buttons (not release): "Fn" and "ALL" one by one, then follow the reverse order to release
button. Please release "ALL" button first, then release "Fn".
- If you hear the device sounded "beep......", setting successfully.
- The built-in speaker of the ZS-2000M will play the IP address of the current device
Alarm System
- 25 -
EN