FONESTAR ZS-2000M Manual De Instrucciones página 8

EN
3. Installing the Microphone Pole.
- Connect the microphone pole at one end in the gooseneck microphone socket of the ZS-200M, and
tighten the pole, as show in Figure 7.
INSTALLING THE ZS-200M ON A CABINET (OPTIONAL)
If it is necessary, the users can choose a rack mount (ZS-200RK) fittings to mount the ZS-200M in a cabinet.
The installation steps are as follows: Buckle the ZS-200M in the rack panel groove, and then cover the rear
cover, and tighten the screws. Refer to Figure 8. After finish the rack mount installation, the ZS-200M can
be installed on a cabinet. Besides, the ZS-200P (Optional) has to be selected instead of removable gooseneck
microphone.
Figure 8 ZS-200M Rack Mount (ZS-200RK) Installation Diagram
CONNECTING THE PROTECTIVE GROUNDING CABINET WIRES
The cabinet door shaft contains one yellow screw as shown in Figure 9, identified with marker ①. Figure 9,
marker ②, represents another grounding terminal in the same position in the cabinet. Connect the two
terminals with a wire.
Connect the grounding screw of all devices in the cabinet to the grounding terminal. For safety reason, it is
recommended to connect an external specified grounding terminal to the one on the cabinet.
Caution:
To prevent a grounding loop, be careful to not let a short circuit occur over the grounding wires.
Figure 7 Microphone Pole Installation Diagram
- 8 -