FONESTAR ZS-2000M Manual De Instrucciones página 8

EN
The following information describes the icons shown in Figure 3:
- Touch the icon to initiate public address and paging.
- Touch the icon to initiate volume setting.
- Touch the icon to monitor broadcasts.
- Touch the icon to initiate the full duplex intercom.
- Touch the icon to view the device IP settings.
- Touch the Group button on the left side of Group/Zone to select groups.
- Touch the Zone button on the right side of Group/Zone to select zones.
- Touch the UP to page up, to display the paging zones of the previous equipment or the groups of previous
page.
- Touch the DOWN to page down, to display the paging zones of the next equipment or groups of the next
page.
- Touch Select All to select all zones.
- Touch Cancel to cancel the selection.
- Touch Paging to turn on the microphone for paging.
- Press the Select All button on the ZS-200M front panel to select all zones, and press the button again to
cancel the selection.
Note: Group, zone, and sound source information can only be defined by Administrators or Super
users. Operators can only select groups, zones, and sound sources.
PUBLIC ADDRESS AND PAGING
The following steps describe how to use the ZS-200M to make a public address or paging:
1. Touch the icon to display the interface as shown in Figure 3.
2. Select the zones or groups that are to receive the broadcast. Multiple zones or groups can also be
selected. A blue status bar appears above selected zones or groups.
3. Select the public address sound sources or make a paging as necessary.
- Touch one of
sources. Select the zones or groups which are broadcasting as needed, and touch CLOSE, the
selected zones or groups will stop broadcasting.
- Touch Paging or press the TALK button on front panel of the ZS-200M to start paging to the selected
zone. The users can set 2 operation modes of the TALK button:
Press and Toggle. The differences between them please refer to the following Note.
Note: Press trigger operation: Press and hold the TALK button to begin paging, and then release the
button to release the selected zones and stop paging. Toggle trigger operation: Press the TALK
button a second to begin paging, and then press it again to release the selected zones and stop
paging.
Figure 3 Public Address And Paging Mode Interface
butters just shown in Figure 3 to select the broadcasting sound
- 8 -