Volume Control - FONESTAR ZS-2000M Manual De Instrucciones

EN
TIME DELAY CANCELLATION
When the ZS-2000M is performing the time delay task and in the delayed state, the delay indicator light turns
on. If the play task is to be performed immediately, then the time delay needs to be cancelled by pressing
the DELAY button. When the button is pressed, the equipment automatically initiates playing.

VOLUME CONTROL

Note: Note that the No, of the zone button is the power amplifier audio channel No.
The sound volume of the power amplifier channels is adjusted by pressing combinations of buttons
simultaneously, as shown in Table 1.
BROADCAST CONTROL FUNCTION
This section describes how to use the ZS-2000M for public broadcasting, including general purpose
broadcasting and fire emergency broadcasting.
The system can play four different sound sources in different zones.
Public Address
Public address includes playing background music, voice messages, and external input sound sources.
When the system is being debugged, the buttons of sound sources corresponding to the sound source in
the software configuration must be set. To make a public address, follow the steps below:
1. Select the zone or zones for the broadcast.
Press the Zone button to select a zone or zones. Multiple zones can be selected. To select all zones,
press the ALL button. Indicator lights for selected zones flash green.
2. Select the sound source or sources to be broadcast.
Press the Sound Source button to select the sound sources.
3. Previewing the sound source is available if the sound source indicator light flashes green.
Press the associated sound source button again to confirm the sound source. Press the CLOSE button
to cancel or stop previewing the sound source. Press the sound source button once more to confirm the
sound source selection and begin broadcasting. If the sound source button is not pressed within a one
minute time frame, the system automatically cancels previewing the sound source.
The sound source is broadcasted according to the configuration policies set in the software. Both
broadcasting in selected zones or a specific sound source that is being broadcasted can be stopped, as
is described below:
To stop broadcasts in specific zones, follow the steps below:
1. Select the zones in which the broadcast is to be stopped.
2. Press the CLOSE button to stop broadcasting in the selected zones.
To stop broadcasting a particular sound source, follow the steps below:
1. Press and hold to the Close button until the following step 2 has finished.
2. Select the sound source button representing the sound source that is to be stopped, and then stop the
broadcasts occurring in the zones that are broadcasting the particular sound source.
Table 1 Power Amplifier Audio Channel Sound Volume Controls
- 4 -