FONESTAR ZS-2000M Manual De Instrucciones página 7

ZS-200M OPERATIONS GUIDE
The ZS-200M has features including an interactive touch panel, the ability to configure preset broadcasting
programs, zone paging, broadcast monitoring, and a full duplex intercom function.
The ZS-200M is also capable of paging and controlling broadcasts on zones throughout the Digital Public
Address and Voice Alarm system..
INITIALIZING THE ZS-200M
The system powers on when the power switch is in the "I" position, and powers off when the switch is in the
The following steps describe how to start the ZS-200M:
1. After connecting the ZS-200M to the power supply, the ZS-200M initialization touch panel displays the
interface that is shown in Figure 1.
2. When the ZS-200M finishes loading, as indicated by the progress bar, the interface shown in Figure 2
appears. Enter the password using the number pad on the right side
1. Touch OK after entering the password. The public address and paging mode is initiated as shown in
Figure 3.
If an incorrect password is entered, and has touched OK, the password field will clear automatically; it is
disabled to enter the operation interface. Touch Reset to clear the password, and enter correct one again.
Note: The system administrators have the necessary privileges required to set and modify the p
assword in the config software, but Operators cannot. The maximum length of the password is
8 characters. If the password is empty, the enter password interface will not display.
Figure 1 ZS-200M initialization interface
Figure 2 Enter Password Interface
- 7 -
EN