Monitor Function - FONESTAR ZS-2000M Manual De Instrucciones

EN

MONITOR FUNCTION

The following steps describe how to use the ZS-200M to monitor a zone:
1. Touch the icon. The interface as shown in Figure 6 appears.
2. Select the zone that is to be monitored. Only one zone can be monitored at a time.
Touch the Up or Down buttons to move up and down the list of zones to find the zone to be monitored.
3. Touch the Start monitoring button to start monitoring the broadcast being played in the selected zone at
the speaker. Press the button again to stop the monitoring function.
FULL DUPLEX INTERCOM FUNCTION
This section describes how to use the ZS-200M to communicate with another ZS-200M.
INITIATING THE INTERCOM FUNCTION
The following steps describe how to initiate the full duplex intercom function:
1. Touch the icon. The interface as shown below in Figure 7 appears.
2. Select a ZS-200M with which to communicate.
3. Touch the Start talking button to initiate the full duplex intercom request.
4. Wait until the opposite party has received the full duplex intercom request.
5. When the opposite party receives the intercom request, the two parties can begin the conversation.
When the opposite party cannot receive the full duplex intercom request, the screen will go back.
RECEIVING AN INTERCOM REQUEST:
1. When a request from another ZS-200M is received, it will be ringing.
2. Select whether to accept the full duplex intercom request.
- Select Start talking to accept the full duplex intercom request.
- Select End talking to return to the previous page.
Figure 6 Zone Monitor Interface
Figure 7 Full Duplex Intercom Interface
- 10 -