Mac allister MPWP1800-3 Manual Del Usuario página 25

MPWP1800-3 by MacAllister
> Unlock the trigger (8h) and squeeze it
until a constant amount of water flows
through the nozzle to allow air trapped
in the hose to escape.
> Release the trigger and switch the
product on.
> Hold the spray gun (8) with both hands.
Direct the water jet to the object to be
cleaned and squeeze the trigger.
WARNING! Beware of kickback when squeezing the trigger!
NOTE: Always keep a reasonable distance between the nozzle
and the object to be cleaned in order to avoid damage. Ask your
specialist dealer for advice if required.
> Release the trigger to stop the water jet.
Tips
WARNING! Prevent water from penetrating the air vents of the
product to minimise the risk of damage to the product.
> Dissolve dirt by applying the detergent mixed with water to the surface while
still dry. Allow the detergent to rest on the surface for a few minutes, but do not
let the detergent dry.
> When dealing with vertical surfaces work from the bottom upwards. Rinse from
the bottom upward, use the high pressure jet at a minimum distance of 30 cm
at 45° angle and then from the top downward.
> In some cases, scrubbing with brushes is needed to remove dirt. High pressure
is not always the best solution for good washing results, since it may damage
some surfaces. The hightest adjustable nozzle jet setting should not be used
on delicate or painted parts, or on pressurised components (e. g. tyres, inflation
valves, etc.).
> Effective washing depends on both the pressure and volume of the water used,
to the same degree.
> Begin by spraying in a testing area free and clear of people and objects.
Wood and vinyl decks
> Reduce your work area to smaller sections and clean each section one at a
time for optimal results.
MNL_MPWP1800-3_MAC_GB_V6_200527.indd 25
Operation
Fig. 16
EN EN
25
5/27/20 5:54 PM