Mac allister MPWP1800-3 Manual Del Usuario página 32

Troubleshooting
EN EN
Troubleshooting
Problem
2. Product does not
reach full power
3. Oil leak
4. Strong pressure
fluctuation
5. Water leakage from
product
6. Excessive vibration/
noise
32
MNL_MPWP1800-3_MAC_GB_V7_200618.indd 32
Possible cause
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source
(e.g. generator) has
too low voltage
2.3. Air vents are blocked
2.4. Water inlet volume is
too low
2.5. High-pressure hose
is leaking
2.6. Seals worn
2.7. Intake filter dirt
2.8. Air being sucked into
the system
3.1. Seals worn
4.1. Nozzle clogged
4.2. Water inlet volume
is too low
4.3. High-pressure hose
is leaking
4.4. Seals worn
4.5. Intake filter dirt
4.6. Air being sucked
into the system
5.1. Seals worn
6.1. Screws and nuts
loosened
6.2. Motor problems
6.3. Water inlet volume is
too low
MPWP1800-3 by MacAllister
Solution
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
2.4. Increase water inlet
quantity
2.5. Replace high-
pressure hose
2.6. Contact your nearest
authorised service
centre
2.7. Clean the filte
2.8. Check tightness of
hose fitting
3.1. Contact your nearest
authorised service
centre
4.1. Clean the nozzle
4.2. Increase water inlet
quantity
4.3. Replace high-
pressure hose
4.4. Contact our nearest
authorised service
centre
4.5. Clean the filte
4.6. Check thickness of
hose fitting
5.1. Contact your nearest
authorised service
centre
6.1. Check screws and
nuts for tightness
and re-tighten as
necessary
6.2. Contact your nearest
authorised service
centre
6.3. Increase water inlet
quantity
6/18/20 6:09 PM