Troubleshooting - Mac allister MPWP1800-3 Manual Del Usuario

MPWP1800-3 by MacAllister
Transportation
Switch the product off and disconnect it from the power supply.
Disconnect the product from the water supply.
Attach transportation guards, if applicable.
Tilt the product towards you until it balances on the wheels. Then move it by its
transportation handle (1).
Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
Secure the product to prevent it from slipping or falling over.

Troubleshooting

Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself
Problem
1. Product does not
start
MNL_MPWP1800-3_MAC_GB_V6_200527.indd 31
Care and maintenance / Troubleshooting
Possible cause
1.1. Not connected to
power supply
1.2. Power cord or plug
is defective
1.3. Other electrical
defect to the product
1.4. Trigger lock has not
been deactivated
1.5. Nozzle clogged
Solution
1.1. Connect to power
supply
1.2. Contact your nearest
authorised service
centre
1.3. Contact your nearest
authorised service
centre
1.4. Unlock the trigger
1.5. Clean the nozzle
EN EN
31
5/27/20 5:54 PM