Aqara E1 Manual De Instrucciones página 11

release the hook of the Smart Curtain Driver until it reaches out to the
maximum length.
2.Install the two adjustable track gliders onto the rail, and put them just
between the first and the second existing track gliders on the movable
side of the curtains(as shown in the figure).
3.Hang the Curtain Driver on the two newly installed adjustable track
gliders
4.Click the setting button twice in succession quickly to hold the Curtain
Driver onto the rail. Right then, the green indicator light keeps blinking,
and there are 3 short beeps from the buzzer a er the product is held in
place, indicating that the installation is complete.
The second track glider
The hook reaches
out to the
maximum length
This product can be configured on the app to open and close the curtains
according to the intensity of ambient light. To use the function, the light
sensor should face the outside of the window and the Curtain Driver
should be installed on the side near the window. If you need to control the
opening and closing of curtains according to the light indoor, the light
sensor should face the interior and the Curtain Driver should be installed
on the side near the interior. To optimize the e ect of the light sensor,
please ensure that there is no opaque object in front of it.
Double-Sided Curtains (two Smart Curtain Drivers are required)
According to the installation method of Curtain Driver for single opening
curtains, hang the two Smart Curtain Drivers on the track gliders of
curtains on le and right sides respectively (as shown in the figure below).
Opening direction of curtains
I-rail
07
The first track glider
The hook is
locked to the
innermost