Battery Charging - Aqara E1 Manual De Instrucciones

Battery Charging

When there is a warning of low battery, please charge the Curtain Driver in
a timely fashion. Charging steps are as follows:
1.Quickly click the setting button twice in succession or use the app to
release the Curtain Driver from the rail, and remove it from the rail;
2.Use the USB charging cable, and plug the end of the Type-C plug into the
charging port on the Curtain Driver and the other end to the adapter for
charging.
3.It takes about 5 hours to fully charge the battery.
Specifications
Dimensions: 145.7 × 96 × 46 mm
Rated Current: 1.5 A
Rated Torque: 0.2 N·m
Wireless Protocol: Zigbee 3.0 IEEE 802.15.4
Model: CM-M01(CM-Curtain Motor series products, M01-the first Motorized
products)
Battery Type: Lithium battery (not replaceable)
Rated Input: 5 V
Rated Power Input: 7.5 W
Rated Rotor Speed：100 r/min
Moving Speed: 12 cm/s
Operating Humidity: 0~95% RH, no condensation
FCC ID: 2AKIT-CMM01
IC: 22635-CMM01
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit di erent from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help."
12