Aqara E1 Manual De Instrucciones página 9

Home app and the Aqara Zigbee 3.0 hub installed (Please scan the QR
code below to download the app).
3.Please open the app, tap "Home" and then tap "+" in the top right
corner to enter the"Add Device (Accessory)" page. Select "Curtain
Driver E1" and the hub to be connected to, and add it according to
instructions in the Aqara Home app. Press and hold the Setting button
for 5 seconds, and wait for the voice prompt from the Hub.
4.If you have purchased two or more Curtain Drivers, please connect all of
them to the Aqara Home app before further installation.
5.If you use double-sided curtains, it is necessary to connect two Curtain
Drivers to the app and then put them in one group for simultaneous
control. Enter the main page of the Curtain Driver to be grouped, click
"... " in the upper right corner, select "Create a group for Curtains" and
follow the instructions.
6.It is recommended to fully charge the product before installation.
Installation Methods
Installation Methods for U-Rail
Single-Sided Curtains (only one Curtain Driver is needed)
1.A er startup, click the setting button twice in succession quickly to
release the hook of the Smart Curtain Driver until it reaches out to the
maximum length.
2.Hang the Smart Curtain Driver on the first and the second glider on the
movable side of the curtains (as shown in the figure).
Tips: If there are extra gliders on the rail, they can be placed between the
first and the second hooks of the curtain, above which the Curtain
Driver can be placed.
3.Click the setting button twice in succession quickly to hold the Curtain
Driver onto the rail. Right then, the green indicator light keeps blinking,
and there are 3 short beeps from the buzzer a er the product is held in
place, indicating that the installation is complete.
05