Troubleshooting - Grundig GKPN46820W Manual Del Usuario

plastic part and removal of prints on the
part. Use warm water and a soft cloth for
cleaning, and then dry it.
• On the products without a No-Frost fea-
ture, water droplets and icing up to a
thickness of a finger may occur on the rear
wall of the freezer compartment. Do not
clean, and never apply oils or similar ma-
terials.
• Use a mildly dampened micro-fibre cloth
to clean the external surface of the
product. Sponges and other types of
cleaning clothes may cause scratches.
• To clean all removable components during
the cleaning of the interior surface of the
product, wash these components with a
mild solution consisting of soap, water and
carbonate. Wash and dry thoroughly. Pre-
vent contact of water with illumination
components and the control panel.
CAUTION:
Do not use vinegar, rubbing alcohol
or other alcohol based cleaning
agents on any interior surface.

9 Troubleshooting

Check this list before contacting the service.
Doing so will save you time and money. This
list includes frequent complaints that are not
related to faulty workmanship or materials.
Certain features mentioned herein may not
apply to your product.
The refrigerator is not working.
• The power plug is not fully settled. >>>
Plug it in to settle completely into the
socket.
• The fuse connected to the socket power-
ing the product or the main fuse is blown.
>>> Check the fuse.
Condensation on the side wall of the
cooler compartment (MULTI ZONE,
COOL CONTROL and FLEXI ZONE).
• The door is opened too frequently. >>>
Take care not to open the product's door
too frequently.
Stainless Steel External Surfaces
Use a non-abrasive stainless steel cleaning
agent and apply it with a soft lint-free cloth.
To polish, gently wipe the surface with a mi-
cro-fibre cloth dampened with water and use
dry polishing chamois. Always follow the
veins of the stainless steel.
Preventing Odours
The product is manufactured free of any
odorous materials. However, keeping the
food in inappropriate sections and improper
cleaning of internal surfaces may lead to
odours.
• To avoid this, clean the inside with carbon-
ated water every 15 days.
• Keep the foods in sealed holders, as mi-
cro-organisms arising from foods kept in
unsealed containers will cause bad odour.
• Do not keep expired and spoilt foods in
the refrigerator.
Protecting Plastic Surfaces
Oil spilled on plastic surfaces may damage
the surface and must be cleaned immedi-
ately with warm water.
• The environment is too humid. >>> Do not
install the product in humid environments.
• Foods containing liquids are kept in un-
sealed holders. >>> Keep the foods con-
taining liquids in sealed holders.
• The product's door is left open. >>> Do
not keep the product's door open for long
periods.
• The thermostat is set to a very cool tem-
perature. >>> Set the thermostat to an
appropriate temperature.
Compressor is not working.
• In case of sudden power failure or pulling
the power plug off and putting back on,
the gas pressure in the product's cooling
system is not balanced, which triggers the
compressor thermic safeguard. The
product will restart after approximately 6
minutes. If the product does not restart
after this period, contact the service.
EN / 19
EN
FR
ES