Identification Of Parts; Correct Operation Checks - Nussbaum TC 110 Manual De Instrucciones

ENGLISH • Instructions manual
7. IDENTIFICATION OF PARTS (FIG. H)
1- Table top rotate pedal
15
7
2- Table top
3- Bead breaker (loosener) pedal
4- Bead breaker arm
9
5- Table top clamp opening/closing pedal
6- Wheel clamp
8
7- Lever for exagonal arm regulation
8- Hexagonal arm
10
9- Horizontal arm
13
10- Filter and lubricator
6
2
11- Rubber wheel support
12- Bead breaker shoe
13- Mounting/demounting head
14- Tyre lever
4
15- Handle for horizontal arm regulation
12
1
11
5 H
14
3

8. CORRECT OPERATION CHECKS

Once the connections described above have been made (See "INSTALLATION"), check to make sure the tyre changer works properly by car-
rying out the following procedures:
1) Depress pedal (1, Fig. H) down: the table top (2, Fig. H) should turn clockwise.
Pull the pedal (1, Fig. H) up and the table top (2, Fig. H) should turn anticlockwise.
2) Open the bead loosener arm (4, Fig. H) manually and depress the bead loosener pedal (3, Fig. H): the
bead loosener will close.
3) Depress the pedal all the way down (5, Fig. H): the four clamps (6, Fig. H) on the table top will open.
When the pedal is depressed again, the clamps should close.
4) Check that a drop of oil drops into the lubricator glass cup (10, Fig. H) after every two or three move-
ments of the footpedals (3 or 5, Fig. H).
Oil feed may be regulated by means of the Lubricator adjusting screw (see Fig. L).
L
TC 110 - Liga C 200
22