Mounting - Nussbaum TC 110 Manual De Instrucciones

7) Repeat the procedure described in points 4 and 5 to demount the lower
bead.

10.4 MOUNTING

CECKING TYRE AND RIM
WARNING: This checking of tyre and rim is of the utmost importance to pre-
vent the tyre from bursting during bead seating and inflating operations!
Before beginning mounting operations make sure that:
- the tyre is not damage and the cord fabric is not damaged.
If you note defects do not mount the tyre.
- the rim is without dents and is not warped.
NB: particularly with alloy rims, dents can cause internal micro-cracks not visible to the naked eye.
This can compromise the rim and can also be a source of danger especially during inflation.
- the diameter of the rim and tyre are EXACTLY the same.
NB: the diameter of the rim is stamped on the rim. The diameter of the tyre is stamped on the tyre wall. NEVER try to mount a tyre on a
rim if you cannot identify the diameters of both.
MOUNTING
1) Apply a liberal amount of manufacturer recommended rubber lubricant to
tyre beads and rim well.
2) If the rim has been removed from the table top, clamp it back on the table
as previously described in the section on "CLAMPING THE WHEEL".
3) Position the mount/demount tool (13, Fig. H) by hand against the edge of
the rim as described under 1,2,3, of the DEMOUNTING procedure.
IMPORTANT: it will only be necessary to re-set the position of the mounting
head if there has been a change in wheel diameter from the previous mounting
or demounting operation.
4) Guide the tyre so that the lower bead is above the forward portion of the
mount/demount head (13, Fig. H : See Fig. O).
IMPORTANT! If the tyre is tubeless, mount it with the valve at 180° from
the tool arm.
5) Now depress the pedal (1, Fig. H) to begin clockwise rotation. Utilize the
wheel's drop-centre area by pushing down on the sidewall nearly opposite the
head to reduce tensional force on the bead as the wheel rotates.
WARNING!
To prevent industrial accidents, keep hands and
other parts of the body as far from the tool arm as
possible when the table top is turning.
6) Insert the inner tube if the tyre has one.
7) Once the lower bead is completely mounted, repeat the previous procedures
TC 110 - Liga C 200
9
8
13
6
2
1
5
26
ENGLISH • Instructions manual
15
7
10
11
14
3
N
4
12
H